Typical Mechanical and Environmental Performance

Jerrik connectors are designed to meet customer specifications and the applicable MIL Specification requirements. The following are the typical requirements for M38999 filter connectors.


Temperature Range -55°C to +125°C
Voltage Range 100 VDC to 2500 VDC

Test Descriptions & Procedures

Cleaning Recommendations

  1. Always cap the front of the connector or mate the connector. The mating face of the connector is not sealed until the connector is mated and the seal put in compression.
  2. Never submerge the connector in any cleaning fluid.
  3. Always position the connector so that cleaning fluids will run off the connector termination area (and will not puddle on the connector).
  4. In an aqueous cleaning machine avoid hot cleaning followed by cold rinse cycles (clean and rinse at the same temperature). A hot wash will expand the shell forcing gasses out of the interior of the connector (creating a partial vacuum), a cold rinse will then tend to pull moisture into the connector.

Please see our SEALED connector options to prevent damage to your filter connectors during cleaning operations.